Infrared Radiation Thermometers On-Line Type IR-BA Series High-speed Compact Radiation Thermometers     The IR-BA series is a non-contact and high-speed compact radiation thermometer. The card sized thermometer with built-in signal converting function of 4-20mA output can easily be installed in narrow places, production lines and small equipment. A standard speed type and a high-speed type (50ms/95%) are respectively available in standard type and small-target/short-distance type and small-target/long-distance type, and special application types for glass, lamp-anneal, film, and burning gas. Features High-speed response Standard: 100ms, High-speed: 50ms Compact & light-weight W32 x H56 x D100 mm, 220g Signal conversion built-in Emissivity setting by digital switch Peripheral units including: Indicator with power supply, converter with reflection correction, etc. CE Excluding special application types (IR-BAX) Models Models Types Range Response D/L Accuracy Wavelength IR-BAT1A General type Standard 0-300°C 100ms 40/500mm Less than 300°C: ±3°C 300°C or higher: ±1% of measured value (at = 1.0 and reference operating condition) 8 to 14µm IR-BAT1B 0-600°C IR-BAT2A Small target/ Short distance 0-300°C 5/80mm IR-BATSA Small target/ 0-300°C 40/1000mm IR-BATSB Long distance 0-600°C IR-BAT1M High-speed type Standard 0-300°C 50ms 40/500mm IR-BAT1P 0-600°C IR-BAT2M Small target/ Short distance 0-300°C 5/80mm IR-BATSM Small target/ Long distance 0-300°C 40/1000mm IR-BATSP 0-600°C IR-BAXG1 Application type Glass 100-400°C 1s 20/150mm ±4°C 4.6 to 5.2µm IR-BAXL1 Lamp anneal 400-1300°C 1s 40/500mm 1% 3.43µm half-band width 120nm IR-BAXF1 Polyethylene 80-250°C 1s 40/500mm ±4°C IR-BAXF2 Polyester 50-150°C 1s 40/500mm ±4°C 7.6 to 8.4µm IR-BAXH1 Burning gas 500-1300°C 10s 100/1000mm 1.5% 4.3µm Specifications Element Thermopile Resolution 0.2°C (0-300°C) general type 0.5°C (0-600°C) high-speed type Emissivity 1.99 to 0.10 by digital switch Analog output 4 to 20mADC (Load: less than 280) Working temperature 0 to 50°C Power 12 to 24VDC Current consumption 60mA or lower Connecting cable Standard 2m 5m for IR-BAXH1 Water proofing JIS C-920 Drip-proof II, IP-X2 Weight About 220g CE EN61326 Class A, EN61326 Annex A Except special application types and extension cable type Conditions for CE conformance 1. An individual DC power unit for thermometer is required.(Recommended power unit: IR-ZFEP) 2. All of the thermometer, the connection cable, and a DC power unit should be used indoors. Stability ±10°C under the EMC test environment *PDF data sheet is available at "Download Center". Page Top BACK